Inspections under this heading typically include a one-time examination of a particular item. If applicable, traffic violations/infractions should be included on a Level III Inspection. NOTE: Mechanical equipment violations specific to a Level I or Level II Inspection should not be included in a Level III Inspection. #Cdl walk around license#As a minimum, Level III Inspections must include, where required and/or applicable: examination of the driver’s license Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate driver’s record of duty status hours of service seat belt vehicle inspection report(s) and carrier identification and status. Level III – Driver/Credential/Administrative InspectionĪn examination that includes those items specified under the North American Standard Level III Driver/Credential/Administrative Inspection Procedure. It is contemplated that the walk-around driver/vehicle inspection will include only those items that can be inspected without physically getting under the vehicle. HM/DG required inspection items will only be inspected by certified HM/DG and cargo tank inspectors, as applicable. As a minimum, Level II Inspections must include examination of: driver’s license Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate (if applicable) alcohol and drugs driver’s record of duty status as required hours of service seat belt vehicle inspection report(s) (if applicable) brake systems cargo securement coupling devices driveline/driveshaft exhaust systems frames fuel systems lighting devices (headlamps, tail lamps, stop lamps, turn signals and lamps/flags on projecting loads) steering mechanisms suspensions tires van and open-top trailer bodies wheels, rims and hubs windshield wipers buses, motorcoaches, passenger vans or other passenger-carrying vehicles – emergency exits, electrical cables and systems in engine and battery compartments, seating, and HM/DG requirements, as applicable. Level II – Walk-Around Driver/Vehicle InspectionĪn examination that includes each of the items specified under the North American Standard Level II Walk-Around Driver/Vehicle Inspection Procedure. NOTE: A five-axle vehicle combination with one axle not measured will still require two defective brakes to be placed out of service under the 20 percent brake criteria. NOTE: If more than 20 percent of pushrod travel on exposed pushrods cannot be measured, then the inspection would not be considered a Level I Inspection and shall be identified as a Level II Inspection. North American Standard Level VI Inspection ProgramĪll Inspection Levels Level I – North American Standard InspectionĪn inspection that includes examination of driver’s license Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate (if applicable) alcohol and drugs driver’s record of duty status, as required hours of service seat belt vehicle inspection report(s) (if applicable) brake systems cargo securement coupling devices driveline/driveshaft exhaust systems frames fuel systems lighting devices (headlamps, tail lamps, stop lamps, turn signals and lamps/flags on projecting loads) steering mechanisms suspensions tires van and open-top trailer bodies wheels, rims and hubs windshield wipers buses, motorcoaches, passenger vans or other passenger-carrying vehicles – emergency exits, electrical cables and systems in engine and battery compartments, seating, HM/DG and specification cargo tank requirements, as applicable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |